1. First of all, before we install the concrete distributor, we need to carefully inspect each component and pipe fastener of the assembled concrete distributor.

2. Secondly, when we are using a tower crane to transport the concrete placing boom, we must also carefully check the spreader used.

3. Then, when the concrete placing boom is in place on the top plate of the formwork, we must first select the position where the concrete placing boom is placed and reinforce the four feet of the concrete placing boom. At this time, it should be noted that the reinforcement should be reinforced under the top plate of the formwork, and the size of the reinforcement should be determined according to the size of the concrete distributor. .

4. Next, when the reinforcement is completed, lower the concrete placing boom, fasten the cable rope, and then lift the weight of the concrete placing boom to ensure the balance and stability of the concrete placing boom.

5. When the concrete placing boom is used for concrete pouring, the spreader is used to distribute the cloth. The spreader base and the fixed frame are fixed firmly with steel pipes to ensure that the spreader is stable, non-shaking, and not inclined during conveyance.

6. While concrete is being poured with a concrete placing boom, the concrete placing boom must be tracked and checked. If problems are found, stop pouring immediately and rectify immediately, and confirm that there are no hidden dangers before pouring concrete.

7. When the concrete placing machine is used for concrete pouring, the base concrete of the concrete placing machine should be cleaned first. After the cleaning is completed, the concrete placing machine is suspended by a tower crane, installed firmly, and the cable wind rope is pulled.